Cisco 400-351 Exam Questions – (Dec-2017 dumps)

Cisco Certified Internet Expert Wireless 400-351 exam is possible to pass with excellence without spending a huge amount of time and money by getting help of VCE2Pass’s 400-351 CCIE Wireless exam questions. Our 400-351 exam dumps material consist of practice test software + PDF Q&A booklet. The success is powered by money back guarantee so your investment is safe either you will succeed or will get the money back moreover you can save 25% of total cost by purchasing the both products together.

400-351 exam questions, 400-351 PDF dumps; 400-351 exam dumps:: https://www.dumpsschool.com/400-351-exam-dumps.html (274 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Cisco 400-351 Dumps Exam Questions and Answers:

Version: 15.0
Question: 21

Which two IETF RADIUS attributes sent by the Cisco WLC can be used to differentiate authentication requests based on the user location?(Choose two.)

A. RADIUS attribute [31] Calling-Station-ld
B. RADIUS attribute [4] NAS-IP-Address
C. RADIUS attribute [95] NAS-IPv6-Address
D. RADIUS attribute [32] NAS-ldentifier
E. RADIUS attribute [303] Source-IP
F. RADIUS attribute [30] Called-Station-ld

Answer: DF

Explanation:

https://supportforums.cisco.com/sites/default/files/ise_location-based_web_portals-v2.pdf

Question: 22

Which three statements about enabling the wireless feature on Cisco Catalyst 4500E Supervisor Engine 8-E are true?(Choose three.)

A. Only the install boot method is supported.
B. Access points must terminate on the same chassis/SUP to join the wireless controller.
C. Visual Switching System must be disabled.
D. Maximum number of access points that can join the wireless controller is 200, and the maximum number of wireless clients that can be supported by wireless controller is 4000.
E. Bundle and install boot modes are supported.
F. Virtual Switching System must be enabled.

Answer: ABC

Explanation:

https://supportforums.cisco.com/document/12515266/sup8e-4500-wireless-installation

http://www.cisco.com/c/en/us/support/docs/switches/catalyst-4500-series-switches/200082-Getting-Started-with-SUP8E-4500-Wireless.html

http://www.cisco.com/c/en/us/products/collateral/switches/catalyst-4500-series-switches/guide-c07-733704.html

http://www.cisco.com/c/en/us/products/collateral/switches/catalyst-4500-series-switches/data_sheet_c78-728191.html

http://www.cisco.com/c/en/us/products/switches/catalyst-4500-series-switches/index.html

http://www.cisco.com/c/en/us/products/collateral/switches/catalyst-4500-series-switches/guide-c07-733704.html

Question: 23

New Updated 400-351 Exam Questions 400-351 PDF dumps 400-351 practice exam dumps: https://www.dumpsschool.com/400-351-exam-dumps.html

You are getting the following error message. Which reason for this issue true?
%DOT11-4-CANT_ASSOC Interface Dot 11 Radio0. Cannot associate NO Aironet Extension IE.

A. “dot11 extension ” is missing under the interface Dot11Radio 0 interface.
B. When repeater mode is used, unicast-flooding must be enabled to allow Aironet IE communications.
C. The parent AP MAC address has not been defined.
D. Repeater mode only works between Cisco access point.

Answer: A

Explanation:

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/12-2_11_JA/configuration/guide/b12211sc/s11rep.html

Question: 24

You have received a new Cisco 5760 Controller and have gone through the initial startup wizard. You are now trying to add APs to the controller, but these are not joining.
Which three checks should you do next? (Choose three.)

A. Check that the radios are not in a shutdown state.
B. Check the country code of the controller. The APs do not join the controller if the country code does not match.
C. Check that the correct time is set on the controller.
D. Check that option 53 has been set in the DHCP scope.
E. Check that the controller has enough AP licenses.
F. Check that the controller has been configured with the correct hostname. Otherwise, DNS resolution fails.

Answer: BCE

Explanation:

Question: 25

You are installing Converged Access controllers that run Cisco IOS-XE and you are ready to implement QoS. From the below, choose all the possible QoS target levels that would apply to downstream traffic (toward the client)?

A. Client, SSID, Radio, Port
B. Client, SSID, Radio
C. Client, Radio
D. Client, SSID

Answer: A

Explanation:

http://www.cisco.com/en/US/docs/switches/lan/catalyst3850/software/release/3.2_0_se/multibook/configuration_guide/b_consolidated_config_guide_3850_chapter_010010.html

Question: 26

Which memchanism incorporates the channel capacity into the CAC determination and gives a much more accurate assessment of the current call carrying capacity of the AP?

A. Static CAC.
B. Reserved roaming bandwidth(%).
C. Expedited bandwidth.
D. Metrics collection.
E. Load-based AC.
F. Max RF bandwidth (%).
G. Admission control.

Answer: E