Juniper JN0-661 Exam Questions – (Feb-2018 dumps)

Juniper Service Provider Routing and Switching JN0-661 exam is possible to pass with excellence without spending a huge amount of time and money by getting help of VCE2Pass’s JN0-661 Service Provider Routing and Switching exam questions. Our JN0-661 exam dumps material consist of practice test software + PDF Q&A booklet. The success is powered by money back guarantee so your investment is safe either you will succeed or will get the money back moreover you can save 25% of total cost by purchasing the both products together.

♥ VALID JN0-661 Exam Questions 2018 ♥

JN0-661 exam questions, JN0-661 PDF dumps; JN0-661 exam dumps:: https://www.dumpsschool.com/JN0-661-exam-dumps.html (133 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Juniper JN0-661 Dumps Exam Questions and Answers:

Version: 8.0
Question: 21

A PE provides VLAN VPLS service to a CE attached with two links. You want to prevent Layer 2 loops and provide link redundancy Which two actions will accomplish this task? (Choose two.)

A. Place both interfaces in a link aggregation group.
B. Configure different VLANs on each interface
C. Configure all VLANs on both interfaces, on the PE, and on the CE
D. Configure Spanning Tree Protocol between the PE and the CE.

Answer: B, D

Question: 22

Click the Exhibit button
R1 is exporting 2000:FEFE:100::/64 to R2 over the EBGP peering session as shown in the exhibit

What will R1 use for this route’s protocol next hop when advertising it to R2?

A. 2000:FEFE:89::1
B. 172.16.1.1
C. 10.1.1.1
D. ::FFFF:172.16.1.1

Answer: B

Question: 23

Referring to the exhibit, you have configured an L3VPN that connects Site-1 and Site-2 together, but the BGP routes are being hidden on the PE routers. The topology in this scenario is shown below.
Site-1 > PE-1 > P-1 > P-2 > PE-2 > Site-2
Which two acttions would allow communication Site-1 and Site-2? (Choose two.)

A. Disable CSPF on under MPLS on P-1 and P-2.
B. Configure DGP on P-1 and P-2.
C. Enable RSVP for all interfaces on P-1 and P-2.
D. Enable LDP for all interfaces on all routers.

Answer: C, D

Question: 24

A layer 2 circuit (RFC 4447) is established between two PE routers to provide connectivity between two customer sites. Which two statements related to this deployment are true?

A. Kompella encapsulation is used in the data plane communications.
B. LDP must be used for the control plane communications
C. BGP must be used for the control plane communications.
D. Martini encapsulation is used in the data plane communications.

Answer: B, D

Question: 25

Referring to the exhibit, which router will be the RP?

A. R4 for all groups
B. R1 for group 224.1.1.11 and R4 for all other groups
C. R1 for all groups
D. R4 for group 224.1.1.12 and R1 for all other groups

Answer: A

Question: 26

You must ensure that r1’s IPv4 loopback address exists in r3’s inet 0 routing table
Referring to the exhibit, which statement is true?

A. An IPv4 unicast realm can be enabled on each router.
B. A policy can be configured on M to redistribute 172.16.100.1/32 into OSPFv2, which would cause r3 to eventually learn the route and place it into inet0.
C. A RIB group can be configured on r3 to copy that route into inet 0 because 172.16.100.1/32 exists in r3’s inet6.0 table
D. A policy can be configured on r1 to redistribute 172 16 100 1/32 into OSPFv3, which would cause r3 to eventually learn the route and place it into inet 0.

Answer: C

New Updated JN0-661 Exam Questions JN0-661 PDF dumps JN0-661 practice exam dumps: https://www.dumpsschool.com/JN0-661-exam-dumps.html