Latest and Valid Network Security Professional NSE4-5.4 VCE Dumps – [2018 dumps]

Network Security Professional NSE4-5.4 exam is possible to pass with excellence without spending a huge amount of time and money by getting help of VCE2Pass’s Fortinet Configuring Monitoring NSE4-5.4 exam questions. Our NSE4-5.4 exam dumps material consist of practice test software + PDF Q&A booklet. The success is powered by money back guarantee so your investment is safe either you will succeed or will get the money back moreover you can save 25% of total cost by purchasing the both products together.

Vendor Fortinet
Exam Code NSE4-5.4
Full Exam Name Fortinet Network Security Expert 4 Written Exam – FortiOS 5.4
Certification Name Network Security Professional
Technology Configuring Monitoring

♥ 2018 Valid NSE4-5.4 VCE Dumps ♥

NSE4-5.4 exam questions, NSE4-5.4 PDF dumps; NSE4-5.4 exam dumps: NSE4-5.4 Dumps (576 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Fortinet NSE4-5.4 VCE Dumps:

Version: 13.0
Question: 1

A FortiGate interface is configured with the following commands:
What statements about the configuration are correct? (Choose two.)

A. IPv6 clients connected to port1 can use SLAAC to generate their IPv6 addresses.
B. FortiGate can provide DNS settings to IPv6 clients.
C. FortiGate can send IPv6 router advertisements (RAs.)
D. FortiGate can provide IPv6 addresses to DHCPv6 client.

Answer: A,C

Question: 2

Which of the following Fortinet hardware accelerators can be used to offload flow-based antivirus
inspection? (Choose two.)

A. SP3
B. CP8
C. NP4
D. NP6

Answer: A,B

Question: 3

Under what circumstance would you enable LEARN as the Action on a firewall policy?

A. You want FortiGate to compile security feature activity from various security-related logs, such as
virus and attack logs.
B. You want FortiGate to monitor a specific security profile in a firewall policy, and provide
recommendations for that profile.
C. You want to capture data across all traffic and security vectors, and receive learning logs and a
report with recommendations.
D. You want FortiGate to automatically modify your firewall policies as it learns your networking
behavior.

Answer: C

Question: 4

What methods can be used to deliver the token code to a user who is configured to use two-factor
authentication? (Choose three.)

A. Code blocks
B. SMS phone message
C. FortiToken
D. Browser pop-up window
E. Email

Answer: B,C,E

Question: 5

You are tasked to architect a new IPsec deployment with the following criteria:
– There are two HQ sites that all satellite offices must connect to.
– The satellite offices do not need to communicate directly with other satellite offices.
– No dynamic routing will be used.
– The design should minimize the number of tunnels being configured.
Which topology should be used to satisfy all of the requirements?

A. Redundant
B. Hub-and-spoke
C. Partial mesh
D. Fully meshed

Answer: B

Question: 6

View the exhibit.
Which of the following statements are correct? (Choose two.)

A. This is a redundant IPsec setup.
B. The TunnelB route is the primary one for searching the remote site. The TunnelA route is used only
if the TunnelB VPN is down.
C. This setup requires at least two firewall policies with action set to IPsec.
D. Dead peer detection must be disabled to support this type of IPsec setup.

Answer: A,B

New Updated NSE4-5.4 Exam Questions NSE4-5.4 PDF dumps NSE4-5.4 practice exam dumps: https://www.dumpsschool.com/NSE4-5.4-exam-dumps.html